Adjusting the Self-propel Drive
Cable
Self-propel models only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1. Loosen the cable support nut (Figure 25).
Figure 25
1.
1 to 1-1/2 inches (25 to 38
mm)
4.
Cable support nut
2.
Self-propel drive bar
5.
Cable support
3.
Cable jacket
2. Hold the self-propel bail 1 to 1-1/2 inches (25 to 38
mm) from the handle (Figure 25).
3. Pull down the cable jacket (toward the mower) until
there is no slack in the cable (Figure 25).
4. Tighten the nut on the cable support.
5. Release the self-propel drive bar and ensure that the
cable is loose.
Note:
The cable must be loose with the self-propel
drive bar in the released position; otherwise, the
mower may creep when the bar is disengaged.
Cleaning the Mower
Service Interval:
Before each use or daily
The mower may dislodge material from under
the mower housing.
•
Wear eye protection.
•
Stay in the operating position (behind the
handle).
•
Do not allow bystanders in the area.
1. With the engine running on a flat paved surface,
spray a stream of water in front of the
right
rear
wheel (Figure 26).
The water will splash into the path of the blade,
cleaning out the clippings.
Figure 26
2. When no more clippings come out, stop the water
and move the mower to a dry area.
3. Run the engine for a few minutes to dry the housing
to prevent it from rusting.
14
