16
Water supply from the water main
•
Connect a supply hose (not included) to the water
inlet of the unit and to the water supply.
•
Open the water supply.
The cleaner can be connected directly to the mains
drinking water supply only if the supply hose is fi tted
with a backfl ow preventer valve as per current regula-
tions in force.
Make sure that the hose is at least Ø 13mm and that it
is reinforced.
Water supply from an open container
•
Unscrew the coupling part for the water inlet.
•
Screw the suction hose with fi lter (not included)
onto the water connection of the unit.
•
Hang the fi lter in the container.
•
Vent the unit before operation.
-
Unscrew the high-pressure line at the high-
pressure outlet of the unit.
-
Switch on the unit and let it run until water free
of bubbles emerges at the high-pressure out-
let.
-
Switch off the unit and screw on the high-pres-
sure hose again.
Failure to comply with the above conditions causes se-
rious mechanical damage to the pump and the loss of
warranty cover.
1. Connect the high pressure hose to the unit’s high
pressure outlet (fi g.5).
OPTIONAL
1/2 inch • 13 mm
OPTIONAL
1/2 inch • 13 mm
fi g. 5
2. Connect the high pressure hose to the spray gun. In-
sert the spray wand of your choice into the wand exten-
sion. Press in against the spring tension and twist into
the locked position (fi g. 6). Insert the nozzle (fi g.2A).
fi g. 6
3. Connect garden hose to unit’s water inlet
(Max 10 bar, max t. 40° C) (fi g. 7).
OPTIONAL
1/2 inch • 13 mm
OPTIONAL
1/2 inch • 13 mm
fi g. 7
4.Connect garden hose to the cold
water source and turn water on completely (fi g. 8).
13 mm
fi g. 8
5. Trigger the gun to eliminate trapped air, wait for a
steady fl ow of water to emerge from the spray nozzle
(fi g. 9).
fi g. 9
•
CAUTION! In order to assist the fi rst startup, it is rec-
ommended to hold the trigger pressed during the
pulling of the starter handle
