![background image](http://html1.mh-extra.com/html/lavor/superwash-160/superwash-160_manual_4075967007.webp)
GB
7
Usage Maintenance Cleaning
To disengage the catch
Press the lock button on the left hand
side of the gun . The trigger is released.
Detergent pick-up
1)Fill the detergent tank
(see photo B, pos.
24)
.
Caution: This appliance has been
designed to be used with a neutral,
biodegradable anionic surfactant based
shampoo. The use of any other detergent
or chemical product may render the
appliance unsafe.
2)
Caution: Before enabling detergent
pick-up, ensure that the regulator knob
is turned towards “-” (low pressure).
• Suck detergent by pulling the spray gun
trigger
• Note: A few seconds may be required
before pick-up starts.
3) Adjust the pressure with the regulator
knob (see chapter “Nozzle with pressure
regulator”).
At the end of a job
1)Switch the unit off by turning the main
switch to OFF
2)Disconnect the unit from the water supply
3)Disconnect the power plug .
4)Purge any residual pressure by pulling
the spray gun trigger repeatedly
5)Clean the water inlet filter (see paragraph
“Cleaning the water filters” in chapter
“Maintenance and Cleaning”)
6)Store the high-pressure cleaner in a dry
safe place (temp.>0
°
C), out of the reach
of children.
Maintenance Cleaning
• Before starting any maintenance work on
the high-pressure cleaner, purge the
pressure and disconnect the unit from the
mains electricity and water.
• Ensure that the air intake vents are always
clean so that air can circulate freely inside
the unit.
• To ensure safe operation, only use original
replacement parts supplied or approved
by the manufacturer.
• When starting the unit for the first time, a
little water may leak from the pump; this
may last a few hours. If you are unable to
adjust the settings and stop this leak,
contact an authorised customer support
centre (see chapter “Guarantee terms”).
• The electric motor is equipped with an
overload cutout system (CL. I). In the event
of malfunction, the unit is stopped. Wait
5-10 minutes before restarting the
appliance. If the trouble persists, refer to
chapter “Troubleshooting” for help. If you
are still unable to resolve the problem,
contact an authorised customer support
centre.
Cleaning the appliance water filter:
• To ensure that the pump works correctly,
it is very important that you regularly check
and clean the water filter.
1)Unscrew the water inlet connector .
2)Pull the filter out of its mounting with
an appropriately sized pair of pliers
3)Clean the filter thoroughly under running
water.
4)Refit the filter in its mounting and screw
the connector back on.
Cleaning the nozzle orifice:
• A clogged nozzle may impair function and
must therefore always be kept clean.
1)Turn the unit off and remove the nozzle
16
18
27
4
28
28
22
23
22