![background image](http://html1.mh-extra.com/html/lavor/single-brush-series/single-brush-series_operators-manual_3941699005.webp)
1
ENGLISH
(Translation of original instructions
)
For safety reasons and to get the most from your single disc machine, make sure
you read and study this manual thoroughly before use.
T h e
SINGLE BRUSH
s e r i e s
i s d e s i g n e d f o r s c r u b b i n g , s t r i p p i n g , s p r a y c l e a n i n g a n d
b o n n e t c l e a n i n g v a r i o u s t y p e s o f s u r f a c e i n c l u d i n g n a t u r a l s t o n e , c e r a m i c t i l e s ,
m a r b l e , g r a n i t e a n d s p e c i a l f l o o r c o v e r i n g s i n c l u d i n g c a r p e t .
S a f e t y :
1. Do not operate the machine:
a)
Unless trained and authorised.
b)
Unless the plug and mains power supply are earthed.
c)
If the power cable and plug are damaged. In this case, you should under no
circumstances use the machine. Contact a service centre to have the cable
and/or plug replaced.
d)
In pools or puddles of water as this could result in electric shock.
e)
If the operator has reduced physical, sensory or mental capabilities.
f)
If the operator is under age.
g)
If the brush is not attached to the machine
2. Before starting the machine:
a)
Make sure all safety devices are in place and functioning correctly.
b)
Position "wet floor" signs as required.
3. When using the machine
a)
Do not run the machine over the power cable.
b)
Do not operate the ON/OFF levers when the handle is in the upright position.
c)
Do not touch the power plug with wet hands.
d)
Do not allow children to play with or near the machine.
4. Before leaving or servicing the machine:
a)
Turn the machine off.
b)
Unplug from the mains socket.
5. When servicing the machine:
a)
Unplug from the mains socket.
b)
Use manufacturer supplied or approved replacement parts only.
c)
All repairs must be performed by qualified service personnel.
Assembly:
1. Attaching handle to base
a)
Unscrew the black bolt from the machine base. Position the handle in the
corresponding screw and tighten the black bolt on the screw.
b)
Press the handle height adjustment lever and place the handle in a vertical
position
c)
Plug the power cable into the switch-housing socket.
2. Mounting optional detergent tank
a)
Attach the top detergent tank bracket to the handle shaft.
b)
Insert the tab at the bottom of the tank into the slot located near the base of the
handle. Secure the top of the tank with the top bracket.
c)
Connect the chain to the detergent control lever. Connect the detergent tube to
Summary of Contents for SINGLE BRUSH Series
