52
EN
NOTE: the microfibre filter (P) must not be used with water
filtering function.
• Sponge filter (Q): (Fig. 60) to be used for liquid suction.
Wash from inside to outside with running water. Best to
replace every 6 months.
• HEPA air filter (X): (Fig. 61) Periodically inspect by lifting
the hooking lever. Best to replace every 6 months.
• Carbon filter (Y): (Fig. 62) has very high filtering capacity. It
traps the motor carbon dust generated during operation.
Inspect monthly by removing the retaining grille; replace if
dirty. Best to replace every year.
CAUTION! Handle with care, do not inhale and keep out of
reach of children.
Y
X
Fig. 61
Fig. 62
15 TROUBLESHOOTING
CAUTION! Repairs should be carried out only by an authorised Service Centre.
Breakdowns may occur when the appliance is not used properly. The following table describes a
few problems and explains how to solve them. If our solutions do not help, call an Authorised
Service Centre.
TROUBLE
CAUSE
SOLUTION
- After switching on, the no-
water pilot light (L) flashes and
the appliance is beeping
- Low water level in the tank (L) - Fill the distilled water tank
- The appliance is ready for use
but there is no suction and
steam
- The quick connector of the flex
tube is not fitted properly
- Make sure that the quick
connector (27) is hooked
properly into the socket
- The steam-ready pilot light is
on but no steam is coming out
- The steam safety lock (32) is on - Release the safety lock
- The steam adjustment knob (J)
is in the closed position
- Turn the steam adjustment
knob (J) to open position
- When working, an attachment
falls off
- The attachment has not been
connected properly
- Connect the attachment
properly
- When working, the suction
power drops
- The attachment is clogged
- Check and clean the attachment
