Mounting
1. Place the bath upside down on flat surface.
2. Position the frame (1) on the bottom of the bathtub so that the edges of the frame become
symmetrical to the bathtub sides and fasten the frame to the bottom of the bathtub with screws (6).
8
4
2
5
3. Install the stud (2) in the frame opening, screw the stud onto the plastic supports (5).
4. Fix the stud (2) on the frame (1) with the nuts (4) so that the support (5) tightly abuts to the plane
of the bathtub side.
5. Fix all the threaded connections firmly.
6. The bathtub height can be adjusted with the help of plastic supports (8). Turn the bathtub over.
7. Install the drain and overflow, prior having removed part of protective film of the bathtub.
8. Draw line on the wall along the upper edge of the bathtub sides. Move the bathtub aside.
9. Mark the openings (4 openings) to install the clamping brackets (7) (3 brackets on the long
side and 1 on the short side).
10. Drill Ø 8 mm openings.
11. Batter in the anchors into the openings and screw in the clamping brackets (4 brackets)
with the self-tapping screws.
12. Connect the drain and overflow to the sewage system.
13. Lift the bath, insert the vertical sides to the brackets screwed to the wall.
14. Fill the bathtub with water and apply sanitary sealant (silicone) on the bathtub surface
adjacent to wall, prior having removed part of protective film.
15. The product should not be used 24 hours for the sealant to harden.
16. After sealant hardens completely, drain the water and remove the protective film from bathtub.
Lavinia Boho
7
