Superabrasive
Owner’s Manual Original Language – Lavina
®
V25G-X
08/2019
12
4. UNPACKING, HANDLING, TRANSPORTATION AND STORAGE
When unpacking the machine, please check that the following accessories are included:
The hose end fitting
Wand
Floor nozzle
Main vacuum hose with Cam Lock to connect to the machine
Accessory vacuum hose with Cam Lock to connect to the wand
If any of the above-mentioned parts are missing, please contact your local distributor or our sales representative.
Protect the environment: Please dispose of packaging materials and used machine components in an environmentally
safe way according to local disposal regulations.
Attention
• During transportation, battery and propane tank must be securely fastened and completely disconnected
at all times.
Attention
• Before operating the vacuum after transportation, propane tank and battery must be re-connected and correctly
assembled.
1. Battery: Make sure that the wires are firmly connected to the correct terminals (black (-) & Red (+). Also confirm that
the bracket that holds the battery in place is correctly assembled, so
that the battery can’t move during operation.
2. Propane tank: Make sure that the tank is firmly held in place by the lock and holder plate where the propane tank sits
on the back of the dust collector. It should not be able to move when correctly assembled.
When handling and transporting the machine , never use the handles or other machine parts to lift the machine. Use
always a skid or pallet for transportation, and never transport an unprotected machine in the rain or snow. Always store
and transport the machine in an upright position. The machine should also always be stored in a dry, frost-proof
environment
5. OPERATION OF VACUUM
IMPORTANT:
Before starting the machine, check the service table for daily maintenance
.
Make sure that the flexible
vacuum hose is securely attached to the vacuum pipe union and vacuum cleaner inlet. Check oil level. Open the
service valve on the propane tank about one and a half turns (counterclockwise).
WARNING:
1. TURN THROTTLE TO THE IDLE POSITION
2. START MOTOR /the engine is started by the key switch/ AND RUN ON LOWEST RPM
3. TURN THROTTLE TO THE FULL POSITION
NEVER START THE ENGINE AT HIGH RPM
Before use, the operator must be trained in the handling of the dust collector and the hazardous dust.
IMPORTANT:
TO TURN OFF VACUUM: 1. CLOSE SERVICE VALVE ON PROPANE TANK
2. TURN THROTTLE TO THE IDLE POSITION
3. TURN OFF KEY SWITCH
Figure 4.1
Figure 4.2
Figure 4.3
