Laversab 6300L, User Manual

Page: 47 / 72

40
Static units must be Feet
Press GO to continue
Pressing “GO” will return you to the Main Screen.
If Static units are in “Feet”, then the following screen will be shown.
A1 A2 A4 B1 B2 B4 C1 C2 C4 D4
CODE: 0 0 0 0 1 0 1 1 0 0
FL. LEVEL : 123
ALT. (ft.) : 12300 1. Target = 12300
If an altitude encoder is electrically connected to the Encoder interface connector on the top
panel of the 6300 (under the Interface Connectors panel) and is pneumatically connected to
the Static output of the 6300, then 10-bit code on line 2 and flight level on line 3 will
correspond to the altimeter reading.
The value of the target altitude can be changed by pressing “1” followed by the desired value,
followed by the ENTER key. The target altitude can be jogged (after pressing “1”) using the
UP-ARROW and DOWN-ARROW keys on the keypad. Changing the target altitude is
meaningful only if the Static output is in “Control” Mode.
The Actual altitude is shown on the left side of line 4. The Actual altitude will change at the
commanded VSI that is setup in the Main Screen. As the actual altitude changes to match the
target altitude, the flight levels will change and the 10-bit code will change.
If an encoder is not connected to the 6300, the flight level will be blank. If the code received
from the encoder is an invalid code, then the flight level will display “XXX”.
Exit this function using the CANCEL key.