Note
Each dose should be programmed using a new cap-
sule and not one previously used.
7.2.3. Hot water dispensing
Put the programming lever (1), situated under the ma-
chine boiler cover, to the ON position.
Place the cup under the hot water nozzle (6).
Press the PROG/STOP key (2) for at least 5 seconds: all
the LEDs of the dose keys light up.
Press the hot water key (5).
When the desired dose is reached confirm it by pressing
the key (5) again.
Press the PROG/STOP key (2).
When the programming is completed, place the pro-
gramming lever (1) to the OFF position.
Note
The temperature of the dispensed hot water can be
changed by using the mixer tap situated inside, on
the back of the machine.
Turn it clockwise to reduce and anticlockwise to in-
crease cold water .
7.2.4. Programming of coffee-cappuccino sequence
(only LB 2800-LB 2810 models)
The machine allows you to decide which sequence to
use when dispensing cappuccino. In particular, there are
three options:
A) dispensing of milk first, then coffee;
B) dispensing of coffee first, then milk;
C) simultaneous dispensing of milk and coffee.
Note
In the simultaneous dispensing sequence (C op-
tion), however there is always a slight delay in cof-
fee dispensing due to the pre-infusion system.
To decide which of the three options to use, proceed as
follows:
- switch the machine off, putting the switch to the “0” po-
sition;
- keep pressed the key of the desired option on the key-
board and at the same time switch the machine on
again: the LED of the pressed key lights up;
- confirm it by pressing the PROG/STOP key (2).
5
2
2
ON
ON
1
5
2
2
5
6
2
2
A
C
B
Manual code 10066574 / Rel. 2.00 / February 2012
13
Maintenance manual for technical assistance
