Place the drain hose into your
standpipe, which should have an
internal diameter of approximately
38mm thus ensuring there is an air
break between the drain hose and
standpipe.
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
If your drain hose looks like this (see the relevant
pcture) you do not require the “U” piece”. Just push
the hose firmly into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove
any blanking plug that may be in place.
Push the drain hose onto the spigot and secure with a
clip if required, ensure a loop is formed in the drain
hose (see diagram) to prevent waste from the sink
entering the washing machine.
The drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece is
available from your local Service Force Centre. The
joining piece must have an internal diameter of 18 mm.
46
Installation
30 cm (12")
38 mm (1.5)
standpipe
diameter
3
pi
n
M
ax
.
90
c
m
.
(35
.
4")
Mi
n
.
60
c
m
.
(23
.
6")
132966571.qxd 21/01/2008 16.14 Pagina 46
Downloaded From WashingMachine-Manual.com Manuals
