LAVAMAT 74950A3, User Manual

Page: 28 / 40

Problem Possible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent
(creates too much foam) has been used.
• Reduce the detergent quantity or use anoth -
er one.
Check whether there are any leaks from one
of the inlet hose fittings. It is not always easy
to see this as the water runs down the hose;
check to see if it is damp.
• Check the water inlet hose connection.
The drain or the inlet hose is damaged.
• Replace it with a new one.
The cap on the emergency emptying hose has
not been replaced or the filter has not been
properly screwed in after cleaning action.
• Refit the cap on the emergency emptying
hose or screw the filter fully in.
Unsatisfactory washing results:
Too little detergent or unsuitable detergent
has been used.
• Increase the detergent quantity or use an -
other one.
Stubborn stains have not been treated prior to
washing.
• Use commercial products to treat the stub -
born stains.
The correct temperature was not selected.
• Check if you have selected the correct tem -
perature.
Excessive laundry load.
• Reduce the laundry load.
The door will not open:
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait until the symbol
9.5
has gone off.
There is water in the drum.
• Select drain or spin programme to empty
out the water.
The machine vibrates or is noisy:
The transit bolts and packing have not been re -
moved.
• Check the correct installation of the appli -
ance.
The support feet have not been adjusted
• Check the correct levelling of the appliance.
The laundry is not evenly distributed in the
drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
28 What to do if…