LAVA Computer MFG Inc.
LAVA eSTS Family Quick Start Guide - Rev C05
2 Vulcan St. Toronto, ON
Tel: +1 416 674-5942
www.lavasimulcharge.com
Canada, M9W 1L2
Toll Free (US & Canada): 800 241-5282
Page 8
Setup Procedure:
1.
Plug the Samsung USB Charger into an AC power source and connect the Micro-USB
connector into the eSTS port marked “Micro-B USB 5V Input”.
For PoE units:
Select eSTS devices can be powered using a PoE Switch/Injector
connected to the Ethernet Port.
For VC units:
Select eSTS devices can be powered using
a 9-36V (12W or better)
power supply, with a 2 mm center positive barrel jack connector, connected to the
port marked “9-36 VDC In”. The attached power supply and wiring are responsible for
providing short circuit protection.
Note:
If using either PoE, or the VC power input,
do not
plug a power supply into the port marked
“Micro-B USB Aux 5V”.
Note:
For VC units, when connecting the LAVA product to the supply, ensure the wiring is such that
the center pin is positive. If the polarity is reversed the damage to the LAVA product is immediate.
Application of the wrong input voltage violates LAVA’s Manufacturer Warranty.
2.
Once the product is powered, the Green eSTS status LED light will start blinking,
indicating that the unit is receiving power.
3.
Plug one end of the Micro-USB cable that is supplied by LAVA, into the mobile device’s
Micro-USB port. Plug the other end into the eSTS port marked “To Tablet”. Ensure that the
cable is oriented correctly as you’re plugging it in. Orienting it incorrectly can damage
both the cable and the LAVA product’s Micro-USB port.
4.
Once the LAVA product is powered and connected to your mobile device, you will receive
a pop-up message requesting permission for LTM to access the USB device. Give the
application permission. It is possible that you will receive this pop-up two to three times.
5.
Once the Micro-USB cable is attached, the Yellow eSTS status LED light will be illuminated,
indicating that a connection has been established with the mobile device.
6.
To verify that LTM has detected the hardware connection, consult the
“
STATUS
”
window
on the LTM homepage on your mobile device. Prior to connecting and powering your
LAVA product, the
“
STATUS
”
window will say
“
CONTROLLER NOT DETECTED
”
(Figure 10).
Figure 10: STATUS window prior to connection of the LAVA product
