Technical Specifications
> Rated Voltage : 120V~
> Rated Frequency : 60Hz
Assembly of fan body
1. Install power cord terminal from iron tube (upper) into the iron tube connector, and then insert iron tube (upper) into the
iron tube connector and fasten them by 2 screws.
2. Insert decorative cover and wiring cover into iron tube (lower).
3. Let power cord terminal from iron tube connector into iron tube (lower), and then fasten iron tube (lower) and connector
by 2 screws.
Assembly of fan body to base
1. Match and fix 6 wheels into their holes of base and press them firmly.
2. Match and fix two terminals from power cord and flume, and then place iron tube (lower) on the flume and fasten by 4
screws.
3. Lift the decorative cover and then fix wiring cover by 3 screws.
Assembly of rear guard
1. Take out the rear guard mounting nut in a counter-clockwise motion.
2. Insert the rear guard into the motor matching 3 rods on the front side of the motor(the handle must be positioned on the
top) to 3 holes of the rear guard.
3. Fasten the rear guard tightly by turning the guard mounting nut clockwise.
Assembly of fan blade
1. Insert the blade to the motor shaft and ensure the pin enters the blade slot.
2. Tighten the blade using the blade cap turning it counter-clockwise in the direction with a “TIGHT” arrow indicated on it.
Note: Proper assembly of the blade is of great importance. Otherwise, the blade spins out of direction and can cause
damage to the appliance.
Assembly of front guard
1. Fix the front guard with the logo in the upright position on the rear guard, and then fasten both guards together by clips.
2. Tighten the screw on the guard by screwdriver.
Note: Do not operate the fan without assembling the guards properly and tightly.
Place the fan on the ground in a level position and add water inside the water tank according to the steps below:
Note:
Unplug the unit from the mains before adding or removing water from the tank. Do not add hot water (40 and
above)in the water tank.
Adding water manually
1. Open the water tank cover.
2. Add water in the flume, take note of the water level.
3. Close the water tank cover.
Note:
Please ensure that water level will not be over the allowable limit to avoid spilling water on the floor. See
picture below.