Première utilisation
Appliance unplugged
Rinsing the boiler
Fix the board in the highest
position. Put the rinsing recep-
tacle beneath the boiler.
Unscrew the drain cap.
Unscrew the filling cap. Pass
the contents of a bottle of tap
water through the boiler to rinse
it. Screw the filling and the drain
cap back on again.
Filling the boiler
1
.
Unscrew the filling cap.
2.
Fill the boiler with water using the bottle provided: it has an anti-overfill device which stops the flow
when the boiler is full (the capacity of the bottle is greater than that of the boiler).
Squeeze the bottle briefly to start the filling of the boiler. Once full, screw the filling cap back on again as
far as it will go.
3
Preparing to use your appliance
CAUTION
Always remove the mains
plug from the socket before
filling the boiler.
ALWAYS Unplug Electrical Cord Before Filling the Boiler
For refilling while ironing,
please follow the instructions
on page 7!
WARNING
WARNING
WARNING
English
For further rinsing, follow instructions on page 8!
Fill up the boiler before every use.
What sort of water?
If your tap water is soft or medium (equal or less than 18°f/11°d/1.8mmol/l), you may use your tap water.
If it's not the case, we advise you to mix it with industrial standard demineralised water: 1/3 tap water -
2/3 demineralised water.
To find out the exact hardness of your tap water, contact your local authorities or water company.
Never use
additives (ex. perfumed water) deionizised water or water softened with salt, neither distilled
water, nor recovery water from the linen-drier, as these products are detrimental to the good quality of the
steam.
Magic Evolution Anglais USA 27.11.2003 14:24 Page 6
