Rinsing the steam generator (cold iron only)
In order to prolong the effectiveness of your appliance and avoid any
traces of limescale, you must rinse the steam generator (15) on a
regular basis.
WARNING : Only rinse with water. NEVER use descaling
products or other chemical products.
Rinse the steam generator in accordance with the following instructions :
• Check that the power plug (23) is disconnected from the mains socket.
• Set the ironing board (1) to its highest position, then remove the water
reservoir (11). Place the drain tray (14) beneath the drain cap (22).
• First unscrew the steam generatorcap (21) then the drain cap (22).
• Remove the small and the large lid from the water reservoir (12). Remove
the filter compartment with the filter (13).
H
• Fill the water reservoir with warm tap water up to the MAX level.
I
• Position the large funnel shaped lid (12) at the place of the water reservoir (11)
on top of the steam generator (15) and position the water reservoir above it.
Then let the water flow through.
J
• Repeat the operation until the water coming out of the steam genera-
tor is free of residues. If no water comes out of the drain opening, call
the Laurastar Customer Service department.
• Once all the water has flown through and the reservoir is empty, screw
the two caps in place again. Dispose of the water. Place the filter back
in the water reservoir, close with the lids and put the reservoir back in
its place on top of the steam generator (15).
To contact Laurastar, visit the Consumer Service menu of our website :
www.laurastar.com
You will find other addresses of official importers and service partners, as well as the complete list of
the Laurastar accessories.
IMPORTANT : before returning any product to the Customer Service department, please refer
to the Problems and Solutions section.
Customer Service
MAX
H
J
I
- 13 -
