Launch TWC-502RMB, Manual

Page: 6 / 34

LAUNCH Tyre Changer(TWC-502RMB)
5
into cabinet through small hole on its right side
plate.
Fig.06
l Take out Slide rod and relevant fastening parts,
brush lubricant on the parts, then assemble them
as in Fig.07.
Fig.07
l Take the bless block on tyre center, assemble it
on fore swivel arm as in Fig.08.
Fig.08
Fig.09
Air Connections
l
After the post and supplementary arm fixed,
disassemble
the sideboard of the cabinet
l
Find air compressing hoses out from the post ,
supplementary arm and airt-tank, insert them
into joint respectively. (Fig.09)
l
Shown in Fig10, get the two outlet airlines
of the air pressure regulator, gauge and
lubricator assembly through the round holes
of the cabinet rear compartment into the
cabinet inside, connect the airline1 with
tyre-inflating airline group (T-joint),connect
the airline2 with the cylinder airline group.
Fig.10
Installation of Air Tank
l Fix the air tank on the cabinet with two sets of
bolts, nuts, spring washers and flat washer (Fig.
11).
l Connect the rubber hose with the joint on the air
tank and fasten the screw of the hose hoop as
figure 11
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn