Troubleshooting
EN
22
ISSUE
POSSIBLE
SOLUTION
Not working
1. Disconnected
2. No electrical power supply
3. Product is power off
1. Connect the product
2. Check if there is a 220-240V~ signal with
another product (such as hairdryer)
3. Push the power button
Low water flow or pressure
1. Clogged filter
2. Twisted hose
3. Nozzle cap is stuck
1. Clean water filter
2. Straighten the hose
3. Clean nozzle cap
Nozzle does not function properly
1. Nozzle is dirty
2. Clogged filter
3. Water pressure is too low
1. Clean the nozzle
2. Clean the filter
3. Adjust water pressure
Washing feature does not work or fails to spray
User not properly seated
Adjust your sitting position
Clean or dryer function suddenly stop
1. Washing time exceeded 5 minutes
2. Time setting activated.
3. Power failure
1. Repeat Cleaning function
2. Revise time setting(page 14)
3. Check power and /or unplug the cord to
reset
4. Press stop button for 10 seconds to return to
default settings (page 7)
Seat not heated
Seat temperature set to off
Reset heated seat temperature
Water not heated
Water temperature set to off
Reset water temperature
Dryer not working
Dryer only operates when seat sensor activated
Sit on product to operate dryer
Remote control failed to be operated
Battery is low power
(low power battery warning display)
Replace the battery (page 20)
Poor flushing performance
1. Clogged filter
2. Installation flow not sufficient
1. Clean water filter (page 19)
2. Confirm that installation can provide more
than 3.5L/10s or remove the flow regulator on
shut off valve
Display shows
- -
Seat sensor problem
Clean and dryer function require seat to be
occupied.
Display shows
E1
Water temperature over specification.
Wait between 5-10 min in order product self
recovery normal temperature.
Display shows
E2
Seat temperature over specification.
Wait between 5-10 min in order product self
recovery normal temperature.
Display shows
E3
Dryer temperature over specification.
Wait between 5-10 min in order product self
recovery normal temperature.
Display shows
E4
System processing.
Wait a few seconds and turn on the function
again .
Summary of Contents for CLEANETINTEGRATED
Page 23: ...EN 23...
