Latitude Pioneer, User Manual, Page: 8 / 20

Tent Assembly
Attaching Mounting Rails
1. After removing the contents, close the tent so the channel mounting
surface is facing upwards (the side with 8 holes in the centre area).
2. Take the mounting rails and align them with the pre drilled holes to
coinside with the desired orientation.
The inner 4 holes are for narrow roof bars under 80cm wide.
3. Slide the 10 mm nylock nuts into the central channel on the mounting
rails and align them with the holes.
4. Now take the 35 mm bolts with the large washers and slide them up
through the holes from inside the tent and tighten.
6
aluminum rail/track
10 mm nylock nut
Tent Base
washer
35 mm stainless steel bolt
Diagram A
Align holes.
Rear Mounted Side Mounted