ATX Installation and User’s Guide
Page 1
Start Here
Master Mode
!! IMPORTANT !!
This AirTime System is designed to provide highly accurate and
reliable time reference in your building. You must follow these
instructions or your clocks will fail to operate properly. You must
allow the transmitter to sit overnight and receive the WWVB signal
before installing your wall clocks.
FOLLOW THESE INSTRUCTIONS BEFORE INSTALLING THE WALL
CLOCKS
1.
Remove the back cover of ATX and slide the Mode Selection
switch to the Master position.
2.
Insert two (2) CR123A lithium batteries (provided) and replace
the back cover or connect the optional 6VDC adapter.
Note: You
can not use both the batteries and the AC adapter at the same
time.
(If the ATX looses power, replace the batteries or check
the optional AC adapter and reset the clock starting at step 1
above)
