Lastec 721XRT, Owner'S Manual

Page: 41 / 58

Initial Set-Up
Pre-Operation Equipment Inspection Checklist
Initial Set-Up Lastec//021819 3-17
3
3.13 Pre-Operation Equipment Inspection Checklist
Perform the following equipment inspection prior to each operation of the Articulator.

With the tractor and Articulator parked on level ground, verify that the Articulator is properly mounted
to the tractor and secure.

Verify that the PTO shaft is properly mounted and secure, and the PTO shaft cover retaining chains
are secure.

Check the oil level in the gearbox.

Inspect area around and under the gearbox for any oil leakage.

Set the deck height to the desired level. If necessary, calibrate the rear deck height chains.

Check the deck drive belt and idler tension spring for proper installation, tension and condition.

Clean the entire center deck area (including under the belt cover) of all grease, oil, fuel, grass, or
debris. Be sure to replace all covers, shields, and guards.

Check all deck belts for proper tension.

Align front decks 1, 2 and 3.

Align outer decks 6 & 7.

Clean each entire deck area (including under the belt covers) of all grease, oil, fuel, grass, or debris.
Be sure to replace all covers, shields, and guards.

Inspect all blades for proper installation, orientation, tightness, sharpness, and overall condition.

Verify proper function of all gauge wheels.

Verify that all warning decals are in place, visible and legible.

Verify that all covers and safety devices are properly installed and secure.

Check that the discharge chute is clear of debris, properly mounted, and in good condition.

Inspect entire Articulator for loose or entangled parts, debris, obstructions, or neglected tools.

Perform all safety, set-up, and pre-operation procedures listed in your tractor manual.

Complete the appropriate maintenance checklist (section 5).