Initial Set-Up
Mower Deck Height Calibration
3
3-16
Lastec//021819
Initial Set-Up
6.
If adjustments are needed on the cen-
ter deck, use the center turnbuckle on
the deck lift assemblies to level the
deck front-to-back. Tolerances for
front-to-back is positive 1/8 inch in the
rear -- the rear should never be lower
than the front edge. Be sure to
retighten the jam nuts on the turn-
buckle after leveling the deck.
NOTE:
On the 73in deck, the rear deck
hangers are also adjustable. Hangers
should have the same tension on both
sides before adjusting the main turn-
buckle. Adjust the eyebolt until the ten-
sion is even on both hangers, then
snug down the jam nut.
7.
When the center deck is level, check
each side deck for levelness.
8.
Inspect the hanger rod to make sure
the urethane bushings are snug, but
not overly tight. Do not use these
hangers for adjustment purposes.
9.
Raise or lower the deck by means of
the small turnbuckle. Be sure to
retighten the jam nuts on the turn-
buckle after leveling the deck
10.
Set the anti-scalp wheel at your “typical”
cutting height. The factory setting is
approximately 1 inch, and should be
readjusted to meet your needs. Do not
allow the anti-scalp roller to be on the
ground constantly or it will result in pre-
mature wear.
LT0117
Measure Here
for Levelness
LT0118
CM0025-4
Summary of Contents for 2561D
