NEW 5/18
2
CT30754ES
SAVE THESE INSTRUCTIONS
• PLUG HEATERS DIRECTLY INTO A 120V WALL OUTLET/RECEPTACLE ONLY. NEVER USE WITH AN EXTENSION CORD. DO NOT
PLUG HEATER INTO ANY OTHER CORD CON NECT ED DE VICE, SUCH AS A POWER STRIP, SURGE PROTECTOR, MULTIPLE OUTLET
ADAPTER, CORD REEL OR OUTLET-TYPE AIR FRESHENER. THE USE OF SUCH DE VIC ES MAY CRE ATE A FIRE HAZ ARD. DO NOT
PLUG MULTIPLE DEVICES IN THE SAME OUTLET OR ON SAME CIRCUIT AS HEATER.
• FAULTY WALL OUTLET CONNECTIONS MAY CAUSE THE WALL OUTLET TO OVERHEAT. BE SURE THAT HEATER PLUG FITS TIGHTLY
INTO OUTLET BEFORE EACH USE. DURING USE, CHECK TO MAKE CERTAIN THE HEATER PLUG IS NOT OVERHEATING. IF NECES-
SARY HAVE A QUALIFIED ELECTRICIAN CHECK AND/OR REPLACE THE WALL OUTLET. DO NOT USE THIS HEAT ER WITH ANY SOL ID
STATE SPEED CONTROL DEVICES.
• Make certain that the power source con forms to the elec tri cal re quire ments of the Heater.
• Extreme caution is necessary when any Heat er is used by or near chil dren or in va lids. The Heat er should not be left op er at ing un at tend ed.
Never leave children unattended when the heater is on or plugged in.
• This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is in tend ed to fit in a
po lar ized outlet only one way. If the plug does not fit fully in the out let, reverse the plug. If it still does not fit, contact a qual i fied electrician.
Do not at tempt to defeat this safety feature.
• DO NOT use the Heater in areas where gasoline, paint, or flam ma ble liquids are used or stored. DO NOT use Heater in lo ca tions where
flammable or explosive chemicals are stored, or in wet at mo spheres.
• Do not operate any Heater with a dam aged cord or plug or after the Heater malfunctions, or has been dropped or dam aged in any man ner.
To disconnect Heater, turn the Heater OFF then remove the plug from the outlet.
• Always unplug Heater when not in use. Unplug pow er cord be fore servicing or moving the Heater.
• Do not insert or allow fingers or foreign ob jects to enter any ven ti la tion or exhaust opening as it may cause an elec tric shock, fire, or damage
the Heat er. Do not block or tamper with the Heat er in any man ner while it is in op er a tion.
• Do not block air intakes or ex haust in any manner. Do not place on soft sur fac es, like a bed, where open ings may be come blocked. Do not
depend on the on/off switch as the sole means of disconnecting power when servicing or moving the heater. Always unplug the power cord.
Read all instructions before using this Heater.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, these instructions and warnings should always be
fol lowed to re duce the risk of fire, electrical shock and injury to per sons:
WARNING
CAUTION
• Always place the Heater on a stable, flat, level sur face when op er at ing, to avoid the chance of the Heater over turn ing. Lo cate the Power Cord so the
Heater or oth er ob jects are not rest ing on it. DO NOT run Power Cord un der car pet ing. DO NOT cover Power Cord with throw rugs, run ners, or similar
coverings as this may cause cord to overheat. Ar range Power Cord away from room traf fic and where it will not be tripped over.
• This Heater is HOT when in use. To avoid burns, do not let bare skin touch hot sur fac es. Always use han dle when moving this Heater. Keep com bus ti ble
materials, such as fur ni ture, pillows, bed ding, pa pers, clothes and curtains at least 3 feet (0.9 m) from the front of the Heater and keep them at least 1
foot (0.3 m) from the sides and rear.
• This Heater is not intended for use in wet or damp lo ca tions. This Heater is not intended for use in bath rooms, laundry areas and similar indoor locations.
NEV ER lo cate a Heat er where it may fall into a bath tub or oth er water con tain er.
• DO NOT use Heater outdoors.
• This Heater is not suitable for use in agricultural facilities including areas where livestock, poultry or other animals are confined. Please refer to National
Electric Code (NEC) Article 547-7 (2008), or applicable state or local codes or standards relating to electrical requirements for Agricultural Buildings.
THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE 547-7 (2008).
• This Heater is not suitable for use in hazardous locations. Please refer to National Electric Code (NEC) Article 500 or applicable state or local codes
or standards relating to electrical requirements for Hazardous locations.
THIS HEATER DOES NOT MEET THE REQUIREMENTS OF NEC ARTICLE
500 (2008).
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/
TV technician for help. The user is cautioned that changes and modifications made to the equipment without the approval of manufacturer could void the
user’s authority to operate this equipment.
Please con tact Cus tom er Ser vice at 800-233-0268 Monday through Friday from 8am to 5pm EST for assistance.
WARNING
NEW 5/18
11
CT30754ES
MODELO CT30754
Si usted pierde su mando a distancia, por favor Cliente de llamada Serive para ordenar un reaplacement en 1-800 -233-0268, de lunes
a viernes, entre las 8 a.m. y las 5 p.m. (Horario Estándar del Este de los Estados Unidos).
CONTROL REMOTO
(Figura 4)
1.
Retire el tornillo de tapa de la batería antes de instalar dos baterías "AAA" (no suministrado).
2. El botón de POWER (encendido) del Control Remoto va indicado con el símbolo (
).
3. Todas las funciones realizadas con el Control Remoto pueden ejecutarse de idéntica forma utilizando los Controles Manuales.
Fig ura 5
Vista Posterior del Calentador
El gancho del control remoto está ubicado en la parte posterior del calentador.
(Figura 5)
Figura 4
Vista
Delantara
Vista
Posterior
Retire el tornillo
antes de la
instalación de las
baterías
