9
Generally
-
Do not use this machine without prior reading this manual. The user/owner of this machine
is obliged to instruct attendants about relevant instructions for its operation in a
demonstrable way.
-
This manual should be available/accessible for attendants any time.
-
This machine is allowed to be operated only by an operator who is over 18 yrs old,
physically and mentally capable and demonstrably instructed about its operation. In
addition to that, he should have a respective driver's license, group B or T (according to a
tractor type).
-
While working, wear always personal protective equipment - protecting shield or goggles,
protective gloves, working shoes and working clothes properly buttoned. Avoid wearing
free parts, such as ties, scarves and shawls, belts etc. Use hearing conservation in
dependence on the tractor noise level.
-
Every operator of this machine is fully responsible for any injury or damage caused to the
third persons within the operating reach of the machine.
-
While working, the operator should stand:
-
- type FZ 560 T-M: behind the cutter rear guard in its working and secured position;
-
- type FZ 560 T-RC:
at least 3 m away from the cutting head, see fig.
-
Keep this machine beyond children's and unauthorised persons' reach. Avoid their
presence while working.
-
Type FZ 560 T-RC: before use, observe the working area if there is no similar equipment
in service which may interfere with the cutter operation or if the cutter itself cannot
interfere with the other appliances and health care facilities.
-
Observe the working area. If any person, children or animals approach while cutting, then
stop working immediately.
-
Before working learn all functions of individual controls and safety elements and carry out
functional checks before any use.
-
Make sure if necessary operating and ancillary space is free and safe.
-
At work in residential zones use the machine in accordance with regulations of the local
authorities to avoid disturbing of local inhabitants (noise, flying chips).
-
Before working make sure if the bottom edge of the adjustable guard covers the cutting
head properly.
-
While working keep an eye on chips gathering behind the cutting head. In case of
excessive accumulation, stop the PTO shaft drive and wait for running the head out. When
the head stops, remove excessive chips.
-
This manual describes problems and faults that may occur at work and that could be
remedied by an instructed person. In case of other problems and faults do not hesitate and
contact the manufacturer. He is always ready to help you.
-
Do never any technical changes or any actions that are neither given in this manual nor
allowed by the manufacturer. This machine, if not correctly installed or adjusted, may run
without problems now but in the future any of important parts could get out of order or do
fatal damage.
-
For replacement of worn or damaged parts use always original spare parts only.
Summary of Contents for FZ560T-RC
Page 5: ...5 EC Conformity Declaration...
Page 6: ...6...
