Laski FZ560T-RC, Operating Instructions Manual, Page: 20 / 35

2 0
Storage
Store the stump cutter always in dry (sheltered) space to protect it against weather effects.
-
Keep the stored machine beyond unauthorised person's reach.
- Before storage clean all parts of the machine. Use pressure water for cleaning.
- Remove any spilled oil immediately and wipe off all oily spots.
- Exchange all damaged or worn parts. Use always original spare parts. For servicing or
spare parts contact your dealer or an authorised service.
- Do not apply any grease or similar agents on elastic hydraulic hoses.
- Put the machine aside always on flat and solid surface.
- Do not put any objects or tools on the machine.
Before Putting into Operation
-
Before the first putting into operation check up the machine for contingent damages and
completeness after its transport and storage.
- Check out tightening of bolted joints, especially of guards and completeness of other parts.
- Check out the cutting head for its condition (attachment and wear of blades, bolts, etc.). If
the cardan shaft is not coupled yet, then it is possible to turn the cutting head.
- Check out condition of the blades. Replace them if worn or damaged.
- Should any damage on the cutting head be detected, it is forbidden to go on working.
- Check out movability of turnable parts respectively functionality of the machine.
- Check out work safety labels for completeness and legibility. Replace any damaged and
illegible label, if necessary.
- Grease bearings and sliding parts according to the Lubrication Plan.
- Check out the hydraulic system for condition and contingent leakage.
- For replacement use always original spare parts. The rotary parts, such as cutting head
and blades, should be balanced properly.
- All blades should be replaced always at the same time as a set. Pay special attention to
their fixing bolts. Replace them if worn or damaged.
- Do not use petrol or similar inflammable matters as a cleaning agent.
- For tractor engine operation use Diesel fuel only (winter Diesel fuel according to season).
- It is strictly forbidden to do any technical changes on the machine.
- If any adjustment is required, do it always at standstill only. Remember blocking the
jib/three-point linkage against unwilling sinking.
- Check out condition and proper tightening of V-belts. Too much slack brings negative
impact on their service life.
- It is strictly forbidden to start the machine with removed guards.
- Type FZ 560 T-RC: remove the battery from the remote control box and let it recharged
(incl. a reserve battery, if any).
- Put the battery in the remote control box and check out all remote control functions.
Coupling to Tractor
Coupling of this cutter to a tractor can be done as an attachment in the top and bottom draw rods
of the three-point linkage, category I or II. For the category II: attachment from the external side