51
Chapter 4. Troubleshooting
Section 1. Error messages
Error Message
What does it mean?
What to do?
"Laser Tube Error Laser
tube is over heat please
press any key to stop."
This means that the laser
tube’s temperature is too
high or the laser tube is
dead.
1.
Turn off the machine to
allow the laser tube to
cool off.
2.
Restart the machine to
see if the same message
shows.
"HPGL Command Error
Get an odd number of
parameters please press any
key to stop"
This means error has
occurred during the transfer
of data from driver to
firmware.
1.
Resend the data file.
"WARNING!
SmartGUARD fire alarm
system is activated, please
reboot machine"
The SmartGuard fire alarm
system has been activated.
1.
Turn off the machine.
2.
Check for fire or smoke.
3.
Clear any hazards.
4.
Turn on the machine.
"WARNING! Emergency
stop is activated, please free
the emergency stop to
continue next job"
The Emergency button has
been pushed down.
1.
Release the emergency
button by turning it
clockwise.
"Please install the Auto
Focus pin first before
performing the auto
focusing or focus tuning"
User is attempting to use
the Autofocus function
while the Autofocus pin is
not installed.
1.
Press “F1” to return
previous menu.
2.
Install the autofocus
pin and to perform
Autofocus.
3.
" HPGL Command Error
Command: Address:
Please press any key to
stop"
The firmware on the
machine and the driver is
not compatible.
1.
Find out the firmware
and driver versions that
are being used.
2.
Upgrade to the most
up-to-date firmware and
driver versions or use
compatible versions.
"Machine Moving Limit
reach upper limit switch
The Z-platform has reached
the top most limit.
1.
Press any key to return
the previous page.
Distributed & Supported by: Jorlink USA, Inc. | Tel: (336) 288-1613 | [email protected] | www.JORLINK.com
52/60
