LaserLiner DampMaster Plus, Manual

Page: 15 / 268

DampMaster Data Plus
4
7
6
1
2
3
5
4
2 sec 2 sec
1.
2.
3.
5
1.
2.
3.
4.
5.
The device features several modes for measuring moisture depending on the type of material. Press the
„MODE“ button to show the corresponding selection: Wood, building material, CM mode, index and
favourites. Use the arrow buttons to select the relevant material group and confirm your selection by
pressing the “MODE” button.
Depending on your selection you will now be presented with a variety of woods or construction materials,
which can also be selected using the arrow buttons and confirmed via the “MODE” button. Once the
material has been selected, the chosen mode will appear at the top of the display and the corresponding
material at the bottom. The current measured value as a % of the material moisture can be read from the
centre of the display.
Selecting the material
Menu language
Hold the two arrow buttons down simultane-
ously to access the menu. Now you can use
the arrow buttons to set the required langu-
age; confirm your selection with “MODE”.
To exit the language menu, hold down the
“MODE” button for two seconds.
red green
yellow
Wet/dry LED display
12-position LED: 0…4 LEDs green = dry
5…7 LEDs yellow = moist
8…12 LEDs red = wet
1 Low battery charge
2 Measured value in % of relative material moisture
3 Selected material
4 Selected material group/number
5 Bar graph
6
Measured value scale
7 Maximum measured value
15 GB