L’ARTISTICO SRL |
EN
30
Cod. 40580 | Rev. 01 | 04/2021
2)
Pull the insert body towards you as far as it will go, open the
tank door and load the pellets with the use of a scoop (scoop).
3)
Strictly close the fuel filler flap Push and close the insert body
by hooking it to the locking system by moving the lever to the
left. After hanging up you will hear a “clack” and the lever
automatically repositions to the right.
WARNING: the pellet loading door must
necessarily remain closed while the appliance is
operating.
Using the appliance with the door open is prohibited as
it alters all combustion values.
Do not overfill the tank with the risk of spilling the
pellets.
It is forbidden to leave pellets on the hot parts of the
appliance, especially on the top cover, it could catch
fire. In case of accidental leaking from the pellet tank, it
must be strictly removed and vacuumed because the
dust can circulate and create dust in the environment.
During loading, make sure that the plastic / paper bag
does not come into contact with hot areas of the
appliance.
However, it is highly recommended not to load directly
from the bag but to use a scoop, making sure there are
no foreign bodies in the bag.
To ensure trouble-free combustion, the pellets must be
stored in a dry place. The use of poor quality pellets or
any other material damages the functions of your
appliance and may result in the termination of the
warranty
and
the
associated
liability
of
the
manufacturer.
Do not allow the accumulation of sawdust on the
bottom of the tank, monthly vacuum the sawdust
deposited inside the main tank.
During operation, if you notice that the pellet tank is empty, DO
NOT LOAD PELLETS INTO THE TANK with the appliance switched
on. Switch off the appliance with the ON / OFF button and only after
finishing the final cleaning and the chimney has turned OFF, you can
reload the pellets in the tank paying close attention to the hot parts (if
necessary use an oven glove to avoid burns). ATTENTION: it is
mandatory to always clean the brazier and the combustion chamber
before re-igniting the appliance. If the described procedure is not
carried out, pellets may accumulate in the brazier with the flame out
with a consequent risk of gas generation and possible internal
deflagration.
19. ELECTRICAL CONNECTION
The connection to the electric current takes place through a normal
cable with an approved electric socket. Check that the power outlet to
which you connect the appliance supports the required electrical load:
230V / 50Hz and 350Watt. Make sure that the electric cable does not
come into contact with hot parts of the appliance, that it does not run
over the connection to the flue, that the network is provided with
regular grounding and safety circuit breaker.
WARNING: The electrical system must be
equipped with a suitable grounding circuit compliant
with the 72/23 EEC, 93/98 EEC regulations.
Make sure that the plug for the electrical connection is
accessible even after installing the appliance and that in
its final position it is not heated by radiation or by
contact with hot parts. Variations in the voltage of the
electricity network exceeding 10% of the nominal value,
may affect the correct operation of the appliance,
causing anomalies in the electrical system of the
product and may lead to the termination of the warranty
and the attached liability of the manufacturer.
1