TPM-GL20004-12C-1227-10C
Larson Electronics, LLC
Phone:
877-348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
4
of
5
BATTERY INSTALLATION AND DISPOSAL
(cont.)
For information regarding the proper disposal/recycling of the batteries contact Larson Electronics at (800) 369-6671
Use only 12v-A23 batteries in the Golight remote control.
USAGE
»
This light is intended for off-road and utility use only
»
This light is intended to be mounted outside the vehicle while in use
»
This light may only be disassembled and repaired by an authorized representative
MISUSE
»
This light is not approved for road or highway use
»
This light is not approved for underwater use
»
This light is not approved for inverted mounting
»
This light is not approved for use inside a vehicle or enclosure and power should be removed prior to placing the
light in such circumstance
»
This light may be damaged if operated in icing conditions
»
This light may only be dismantled by an authorized Golight representative
»
Any violation of the above referenced misuses will be considered grounds for warranty refusal
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 100V - 277V AC, 50 or 60Hz
except those factory ordered with low voltage 11V to 25V AC/DC.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
WIRING
