![background image](http://html1.mh-extra.com/html/larson-electronics/tpm-gl20004-12c-1227-10c/tpm-gl20004-12c-1227-10c_instruction-manual_3900544004.webp)
TPM-GL20004-12C-1227-10C
Larson Electronics, LLC
Phone:
877-348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
5
PROGRAMMING
The 12 Volt DC power wire should be joined to the leads under the lamp with appropriate automotive wire attachments.
The light is not polarity sensitive. Power should be fused at 10 Amps and be on a dedicated circuit, or wired to an
appropriate automotive relay system.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight® RadioRay® is controlled with a programmable remote with 2187 different channels. This feature allows you
the freedom to change the channel selection, and the receiver relearns the new selection.
PROGRAMMING THE TRANSMITTER
This light has been pre-programmed at the factory, and it is not necessary to re-program the transmitter, unless you
experience outside interference.
1. IMPORTANT: Disconnect power by removing fuse or disconnecting vehicle battery.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive, negative and neutral.
Use a small screwdriver and select a position for each dip switch. *Please note that the orientation of the +/– switch
positions may vary among different models of wireless remote controls.
4. Insert both A23 12V batteries with the +/– in the same direction. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED
will light.
b. While holding the on/off button down, reinstall the power (replace fuse or connect power cord).
c. Keep your finger on the on/off button for 5-6 seconds and then release. The light should now be programmed.
LIGHT OPERATION
1. Using the remote control, turn on the light by depressing the on/off button.
2. With the 4-way arrows on the remote control, rotate your light to the desired location. Depending upon conditions,
the wireless remote may be used up to 80 feet from the RadioRay®.
3. The speed of the light rotation can be controlled by depressing the tortoise/hare button one time and by depressing
it again to restore the original speed.
4. The spotlight should not be turned on when the snap on lens cover (rockguard) is attached. (Not applicapble for
LED)
BATTERY INSTALLATION AND DISPOSAL
Remove Battery Cover:
Remove the Phillips head screw securing the battery cover then remove the cover. With the
battery compartment now exposed, insert batteries according to correct polarity. Remove the batteries by gripping the
positive end of each battery and lifting.