Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
RML-8
POWER
1.
The charger will have a green indicator light when the battery is fully charged.
Note:
While the charger is intelligent enough to back off the charger when the battery is fully
charged, it is not recommended that you leave the light on the charger indefinitely. Ultimately,
the heat created by the charger and the battery will ultimately degrade the components.
Leaving the battery charging for a day is not a big deal, but leaving the battery charging for
weeks or indefinitely will degrade the life of the charger and the battery.
2.
The charger will have a solid red indicator light when the battery is charging.
3.
Charging time will vary based on the battery’s condition. Maximum charge time is 4 hours.
4.
You can run the spotlight from the charger when it is plugged into the wall. While the spotlight
will run, the battery will not charge in this state.
5.
This spotlight has a lithium ion battery. You can charge this battery as little or as much as you
like without “memory” issues.
6.
Lithium ion batteries generally will discharge very slowly on the shelf. You can expect a fully
charged battery to last 9‐12 months on the shelf if fully charged when stored.
BEAM ADJUSTMENT
The lens/reflector assembly is threaded onto the center post. Rotating the lens/reflector causes
the beam to expand or contract. Counterclockwise rotation creates a wider flood. Clockwise
rotation creates a narrower, longer spot beam.
The lens/reflector assembly can be removed completely to change to the red lens or while
changing the bulb.
REPLACING THE BULB
This spotlight takes a standard H-3 bulb and can be purchased through most automotive stores, or
through our website.
(Part Number HL-8X-SB)
Remove the lens/reflector assembly by rotating counterclockwise until fully unthreaded. Pull the
assembly out away from the light to remove.
Unscrew the ring holding the bulb in place. The bulb will fall loose.
Remove the 4 screws holding the top cover in place.
Disconnect the bullet connector holding the white wire to the light.
Pull the bulb loose from the front of the light.
Insert new bulb, white wire first and connect the bullet connector
Replace the top cover and 4 securing screws.
Place flat plate of bulb into mounting hole.
Replace chrome ring and tighten into place.
Ensure that the bulb has seated flush against the plate and there is no gap between the chrome
ring and the shaft.
