Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
CHANGING THE BATTERY
The battery is not designed to be “swapped out” in the field. It can be done, but it is not designed like a
cordless drill, where you just snap it in and out.
1.
Remove the 4 screws holding the top cover in place on the rear of the main housing. This is the
squared section. The 4 screws can be seen when you turn the light upside down. Once the top
cover is removed, you will see the battery pack.
2.
The battery pack consists of 6 cells welded together. A single Molex style connector brings
power from the battery to the bulb. Disconnect this connector and remove the battery pack as a
whole. Double sided tape secures the battery pack. Be sure that if the tape has lost its adhesion
that you replace it when you replace the battery pack.
3.
Replace the battery pack, reconnect the power and replace the top cover.
Lithium ion batteries have a very long life. You should not need to replace the battery pack very often.
DETACHABLE CORDS
The cords are detachable by depressing the tab on the top of the connectors. This enables the
operator to leave the cord connected to the power source and remove to store the light.
Additional or replacement cords can be ordered from our website.
*We offer 16 foot coil cords with a cigarette plug (C-16-CC-CP), 21 foot cords with ring terminals (C-21-
RT), 16 foot cords with battery clamps (C-16-BC), and 16 foot straight cords with cigarette plugs (C-16-
CP).
