PTB-1-M-30C-4C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
8
4.
Attach and run the power cables. Take the
25
’ cable
w/inline remote and securely attach the female connection
to the base.
5.
Attach the hardwired remote to the other end of the cable
by screwing the female end of the remote assembly to the
male end of the wire harness.
6.
If your unit will be hardwired, keep the flying leads
attached to the remote and hardwire the unit. Use the pin
tab to remove the flying leads and attach the cigarette
plug adapter if needed.
7.
Find a location to mount the base for the hardwired
remote. Use the two screws provided.
8.
Apply power to the unit to ensure proper function.
How to Mount the Pan/Tilt Base
1.
Determine the location you want to mount the base to.
2.
Attach the pan/tilt base to your surface using the four
corner thru-
holes at the base of the unit. Use the provided
bolts to mount the base.
Be sure the unit will move freely
and won’t contact the wall, ceiling
or pole during
operation.
3.
Bolt your device to the mounting plate on top of the unit
and secure it tightly.
If necessary, use the included 8x10”
mounting plate.
Optional:
Connect your device to one of the indi/-leads on the base.
Seal off the additional wire if not used.