PTB-1-M-30C-4C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
8
•
Cord is attached via a weatherproof 2-pin Deutsch connector.
•
The cord is detachable by depressing the tab on the top of the connectors. This enables the
operator to remove and store the light while leaving the cord connected to the power source.
•
Additional or replacement cords can be ordered from our website. Contact us or visit LarsonElectronics.com for more
information.
INSTALLATION NOTES
•
Read this user’s manual thoroughly and retain it for future reference.
•
Use a damp cloth to clean the unit.
•
Never attach anything to this unit that could lead to danger.
•
Do not install this unit to a surface that could become unstable such as a stand, tripod, shelf or table.
•
Install the unit in an open area away from heat sources.
•
Always use the voltage listed on the unit.
•
Keep objects and cables away while the unit is in operation.
•
Do not electrically overload this unit to prevent a risk of fire.
•
Contact an electrician for installation if you are not familiar with electrical wiring.
Attach supply line wires to the appropriate light fixture wires as shown in
the diagram
Secure each pair of wires according to the diagram. Utilize a junction box
or similar device and take precautionary steps for
weatherproofing all connections if installed in a location where water may
come in contact with the unit. Ensure the unit is properly grounded and that
wiring is done according to all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
DETACHABLE CORDS
Low Voltage DC
Connect power to power supply outputting low voltage between 9-42 Volts DC.
This variable voltage allows greater versatility without affecting light output. Ensure
deutsch connectors are properly connected (If applicable)
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor
areas where weatherproofing may be required. Universal voltage driver permits operation at
12V or 24V DC
.
Warning:
Check product label for correct input voltage!