LED SEMI-CUTOFF
Installation
Guide
&
WARNING :,__--------------
�
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
- To prevent personal injury or product damage only licensed electricians should install.
- To avoid electric shock or component damage disconnect power before attempting installation or servicing.
- This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
- Disconnect product and allow cooling prior to servicing.
- Any alteration or modification of this product is expressly forbidden as it may cause serious personal injury, death, property damage and/or product malfunction.
- To prevent product malfunction and/or electrical shock this product must be properly grounded.
- This luminaire is designed to operate in ambient temperatures ranging from -30' c to 45' c and to be horizontally mounted with the LEDs facing down.
- Wall mount only.
1. Unpacking
Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.
2. Installation
I) . Take off the screw of the heat sink and take off the front lid carefully from the back.
The angle between the front cap and the back cap should be 0-45 degrees.
3). Connect wire A with wire C (The black one is L, white one is N,
and the yellow one is ground wire), installing the front cap .
•
t
3. Installation of the photocell
Photocell input voltage range 120V or 277V, 60HZ,
I). Pick a ½" cap of either side of the product and install the photocell
according to the picture.
4. Checking
1 ). Does all the wires connected in a correct way as the pictures below show?
2). Is the ground lead installed appropriately?
3). make sure the photocell function well.
2) . A: After determining a place to put a conductor, take off the½" cap and make a hole
according to the example (B). Fix it on the wall with an appropriate screw. (Please use
glue to block the hole to prevent water leakage. )
2) . B, When installing the junction box, take off the ½" cap of the C wire in the middle.
This product supports standard 3 ¼" and 4" junction box. After installing the back cap on
the wall ,use waterproof sealer to seal it.
A
A-1/2" NPS tapped holes (surface conduit or photo control)
B-5/16" dia screw hole
4). Make sure all wires are connected correctly, and lock up with the screw .
2). complete the photocell system after installing the
photocell.
Bl.\
Red
LEDHWP-SC-1500
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
