![background image](http://html.mh-extra.com/html/larson-electronics/led10w-1s-10-75c/led10w-1s-10-75c_instruction-manual_676976002.webp)
LED10W-1S-10.75C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
WARNING: Bolts, Nuts, and Washers are Stainless Steel. DO NOT USE Pneumatic or Electric
Tools to Tighten and Loosen. The Hardware Will Permanently Lock Together.
MOUNTING INSTALLATION INSTRUCTION
1.
First, attach Solo Mount to Light using provided Set Bolt(B1)
and Allen Key(A1).
2.
Next, place the light on the location where it will be mounted.
3.
Determine where the Solo Mount bolt will be placed, and
mark where the bolt location will be.
4.
Drill a hole for the Solo Mount bolt.
5.
Place the light over the hole, and then slide the bolt through
the drilled hole.
6.
Slide the Nylock Nut on the opposite side of the drilled hole,
and fasten until properly secure.
4
OMNI-LINK INSTRUCTIONS (OPTIONAL)
1.
Using the provided Omni Link (O1),
slide the link into desired top or
side
notch of the light.
2.
Set in place using provided Set Bolt
(B1) and Allen Key (A1).
3.
Repeat using second light to link
both lights together.
MOUNTING KEY
TIP:
For complete application guide see website
1
1. Solo Mount
2. Bolt
2
3. Mounting Surface
4. Nylock Nut 5mm
3
COMPONENTS KEY
1.. LED Lig
2.. Pigta
3.. Wire to Power Sour
MAINTENANCE
1.
All models have been designed for maintenance
free use. In the case an LED lamp or other part
replacement is needed please contact
Larson Electronics
.
WIRING INSTALLATION INSTRUCTION
1.
Supplied with the Solstice Solo is a 3” Pigtail.
2.
Connect the positive (red) Pigtail wire to the positive wire of
your power source. Repeat this step
for the negative Pigtail
wire (black) as well.
3.
Now that power is connected to the pigtail it is ready to plug
into the LED light for use.
3
2
1