![background image](http://html1.mh-extra.com/html/larson-electronics/hal-trn-series/hal-trn-series_instruction-sheet_3732387002.webp)
Larson Electronics, LLC • 9419 US-HWY 175 • Kemp, TX 75143
Page 2
MOUNTING INSTRUCTIONS: (see figure 3)
Mount luminaire trunnion to Yoke mount bracket with 2-1/2"
bolts & 2-1/2" lockwashers supplied with bracket.
Mount
yoke bracket with 1-3/4" bolt (supplied by others).
Yoke
mount may be locked in position with 1-3/8" bolt (supplied by
others).
MOUNTING INSTRUCTIONS: (see figure 4)
Mount wall or clamp mounting bracket to pole with U bolt and
nuts supplied with bracket in desired position on pole.
Tighten nuts to secure in position. Mount luminaire with trun-
nion & yoke mounting brackets already installed, to wall or
clamp mounting bracket with 1-5/8" bolt (supplied by others).
Install 1-3/8" bolt (supplied by others) thru yoke mounting
bracket and into wall or clamp mounting bracket. Tighten bolt
after aiming luminaire in desired direction to lock in place.
POLE MOUNT BRACKET: (see figure 5)
NOTE: Flexible cord or cable shall be for extra hard wet
locations usage and have a temperature rating as indicated
on the luminaire nameplate. Cord should have a diameter
between 0.5" and 0.625" (13mm - 16mm). Cords outside of
this range may prevent the proper functioning of the clamp
and result in water ingress.
1. Loosen two screws on pressure plate for cable entrance.
2. Feed pole and bracket cable through cable entrance (#16
AWG (1.5mm) cable recommended).
•Leave at least 10" (254 mm) of slack to make connections
inside luminaires.
•Tighten pressure plate.
3. Mount pole mount bracket onto pole and tighten mounting
bolts.
4. Remove 2-luminaire mounting bolt(s).
•Mount luminaire to pole mount bracket and secure mount-
ing bolt(s) tightly.
FIGURE 5
FIGURE
4
INSTRUCTIONS FOR POLE MOUNT BRACKET
PRESSURE
PLATE WITH
GASKET
VERTICAL
MOUNTING
HORIZONTAL
MOUNTING
SUPPLY
CABLE
CORD
GRIP
PULL 10" AND ENOUGH
CABLE FOR DRIP LOOP
IN LUMINAIRE WIRING
APPLICATION
POLE
MOUNTING
BOLTS
LUMINAIRE
MOUNTING BOLTS
FIGURE 2
ROLL PIN
Classified duty
floodlights have
1/2" N.P.T.
tapped hub for
power entry.
Trunnion
Adjust locking
bolts for lumi-
naire alignment
Bolts
Yoke Mount
Bracket
Trunnion
Pole
3/8-16 UNC X 1"LG
5/8-11 UNC X 2"LG
U Bolt
with nut
Wall or
Clamp
Mounting
Bracket
Yoke Mount
Bracket
Adjust locking
bolts for lumi-
naire alignment
CAUTION: Luminaire with optional photocontrol or
quartz auxiliary lamp does not comply with UL
requirements for use in classified locations.
FIGURE
3