Larson Electronics, LLC • 9419 US-HWY 175 • Kemp, TX 75143
Page 3
WIRING:
HAL-TRN
luminaire with Slipfitter:
All 480 volt models are inter-
nally prewired.
Models with multi-tap ballasts require connecting
the black slipfitter lead to the ballast.
• Open
HAL-TRN
luminaire by loosening 4 captive screws and
allow the cover to swing down. Remove the three cover screws
covering the ballast compartment. Select the multi-tap ballast
primary lead of the proper voltage and splice to the black slipfitter
lead (see multi-tap caution label on ballast).
• Open slipfitter wiring compartment by loosening 2 screws and
removing compartment cover. Connect slipfitter leads to voltage,
neutral, and ground supply cable conductors.
NOTE:
If post of pole is 25 ft. or higher, the power supply conductor lines
must be supported.
• Loop the power supply lines around the support rod as shown in
Figure 7. Pull line to reduce the size of knot and insert in the
wiring compartment as shown.
• The weight of the supply wire will hold the rod in place.
• Complete the wiring.
FIGURE 7
FIGURE 6
Slipfitter Mount
NOTE: Do Not use on ungrounded 480V circuits.
