GL-3XXXST Series
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
5
4.
Drill a center hole in mounting surface for passage of power leads. Minimum suggested diameter is 6 mm (1/4 inch).
5.
The wire leads under the light need to be connected to a fused 12V DC power source on the vehicle. It is critical that
polarity be observed. See amp draw and recommended fuse sizes below. Connect vehicle positive (+) to spotlight
posi-tive (+) wire. Connect vehicle chassis ground (-) to spotlight ground (-) wire. Use appropriate wire gauge and
fuse for your light and appropriate automotive wiring connectors.
Electrical requirements are as
follows:
Halogen Models
Max Current Draw: 5.5A @ 13.8V
Recommended Fuse: 7.5A to 10A
LED Models
Max Current Draw: 3.5A @ 13.8V
Recommended Fuse: 5A
6. Use silicone sealant to fill center hole around power cord. IMPORTANT: Allow 75 mm (3 inches) of cord to remain
under light to ensure full 370 degrees rotation.
7. Ensure gasket is mounted on the base of the spotlight. Silicone or other like sealants should not be used around the
mounting gasket as it will limit the ability to drain water properly.
8. Wet the mounting surface with a small amount of water to ease installation.
9. Tipping the front of the light down, first push it forward and then pull backward causing the front bracket to hook into
the mounting plate. Refer to Figure 1.
10. Seat the rear bracket and base onto the mounting plate. Peel back the tab at the rear of the mounting gasket to
gain access to the screw hole. Install dog point screw through base and rear bracket and tighten into mounting plate.
11. Mechanical installation is now complete.
BATTERY INSTALLATION – ST WIRELESS REMOTE
1.
Remove the battery compartment cover from the rear of the handheld remote by removing the single rounded head
screw. Note that cover is hinged at the top.
2.
Insert the two supplied AAA 1.5V batteries. Note batteries must be installed with proper polarity (+ and - ) as shown
inside battery compartment. See Figure 3.
3.
Reinstall battery cover and screw.
Figure 3
– ST Wireless Remote
