GL-2000-24
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
5.
Replace battery cover.
a.
Depress the on/off button and hold it down. Red LED will light.
b.
While holding the on/off button down, reinstall the power (replace fuse or connect
vehicle battery).
c.
Keep on/off button depressed for 5-6 seconds, and then release. The light should now
be programmed.
USAGE:
This light is intended for off-road and utility use only
This light is intended to be mounted outside the vehicle while in use
This light may only be disassembled and repaired by an authorized representative
MISUSE:
This light is not approved for road or highway use
This light is not approved for underwater use
This light is not approved for inverted mounting
This light is not approved for use inside a vehicle or enclosure and power should be
disconnected prior to placing the light in such circumstance
This light may be damaged if operated in icing conditions
This light may only be dismantled by an authorized representative
Any violation of the above referenced misuses will be considered grounds for warranty
refusal
Lens installation:
Press the flood lens up against your Golight until it clicks in place. Press all edges
to ensure the lens is securely attached flush with the Golight lens.
To remove the flood lens, pull two edges until the lens releases from the Golight. Store in a safe
place.
Note:
Ensure the lens lines up properly. Do not force the lens as this could cause damage to the
lens and/or Golight
If the lens becomes dirty, wash with a mild soap and water.
IMPORTANT SAFETY INFORMATION
This symbol is to alert you to important operating or servicing instructions that appear in your instructions. Always follow
basic safety precautions when using this product to reduce the risk of injury, fire or electric shock.
This light is for off road and utility use only. It is not designed for road use as a driving light.
The GL-30204 complies with Part. 15.105 of the FCC Rules. This equipment has been tested and found to comply with the limits for
a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
FCC RULE Part. 15.21 - Changes or modifications made by the user not expressly approved by Larson Electronics, LLC for
compliance could void the user’s authority to operate the equipment.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD FURTHER
INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE
AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
