FITS
4”x 4”
or 6”x 6”
POST
USE AND CARE GUIDE
POST CAP LIGHT
MODEL # NEB-LSP-0006
A
Light Body (1)
B
Connector Clip (1)
C
Screws (2)
1. Preparation
• Before beginning assembly, compare parts with package
contents list to make sure all are present. If any part is
missing or damaged, do not attempt to assemble
the product.
• Required tools: Phillips Head screw driver
2. Assembly
• Determine if your fence or deck posts measure at 4”x 4” or
6” x 6”. If they are 6” x 6” you will need to remove the post
adaptor bracket.
• Attach the cap light unit over the post and pull the light wire
to hang over the side toward the transformer wire. Screw
in the mounting screws (C) through side holes in the light
body (A).
3. Installation
• From the transformer (sold separately) run a wire
(sold separately) along the base of the fence or deck.
• Secure the Connector Clip (B) to the transformer wire, as
shown above.
• Repeat this process for every post cap light installed.
• Test the connection by turning on the lights. Make any
desired adjustments.
• Complete the install by tacking the transformer wire under
the lip of the deck or burying along the fence line in a small
trench and back filling with dirt.
A
C
ASSEMBLY AND INSTALLATION
WARNING:
The wire connector (B) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION:
The wire from low voltage power unit should be 12-18 AWG type
underground Low Energy Circuit Cable.
IMPORTANT:
• Do not submerge the fixture in water.
• Do not install the fixture within
10 ft. of water.
•
The landscape wire can also be
hidden under surface.
•
Protect the wiring by routing it in
close proximity to the light fixture,
or next to a building structure.
(Power Pack Sold Separately)
B
