EPL-DL-24-12W-WF.24
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
Assembly Guide
Explosion Proof Dock Fan/Light Combination
with Adjustable Arm - 24" Fan - 12W LED Lamp
The explosion proof dock fan/light combination unit arrives in several parts for shipping. Follow the steps below
to assemble the unit.
The explosion proof dock fan / light has been disassembled in three parts.
1
2
3
1.
Dock Mount Adjustable Arm
2.
Explosion Proof Fan / Explosion Proof Camera Assembly
3.
Mounting Pole for Explosion Proof Fan
Tools required:
•
Drill / Wrench (9/16” & 7/16”)
Additional help for maneuvering unit is also necessary.
All bolting hardware is pre-place on the unit. Remove the bolts / nuts /
washers prior to attaching each part.
1.
Locate all pieces shipped with the unit.
(FIGURE A)
2.
Install Mounting Pole to Explosion Proof Fan.
a.
Locate and remove bolts already attached to base of fan.
b.
Place flat side of mounting pole into receiving base of the
fan.
(FIGURE B)
c.
Use a 9/16” wrench for the top bolt & 7/16” for the bottom
adjustment bolt.
(FIGURE C)
Note:
Adjust fan to the desired angle after installation.
3.
Install Dock Mount Adjustable Arm to surface. This can be
installed to the surface before step 4 or after step 5.
Note:
The fan
and light will add weight to the dock mount.
(FIGURE D)
a.
There are six pre-drilled mounting holes available for
mounting dock mount to the surface.
b.
Utilize all six mounting holes to secure dock mount to
surface. The explosion proof unit is heavy, therefore; the
surface and hardware used
MUST
be capable of
supporting the weight.
9/16”
7/16”
A
B
C
D
