EPL-48-2L
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
5
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 1
2
0V - 277V AC, 50 or 60Hz
.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
ADJUSTABLE SURFACE MOUNTING BRACKETS
Each bracket is cinched to the bracket mounting peg on each side of the light. The angle of the bracket is set by tightening
two cap screws on either side of the bracket. The cap screws act as a set screw. The bracket itself is mounted via a single
bolt hole at the top the bracket. There are two brackets, one on each end of the light. Once the brackets are mounted to a
surface (ceiling, floor or wall), the light fixture can be removed from the brackets by loosening the cap screws that hold the
bracket to the mounting peg.
SUSPENSION MOUNTING
Pendant mount fixtures hang from the ceiling and are suspended by rigid pipe. Each fixture features a 1/2” NPT junction box
on one end, and a 1/2” NPT adjustable L-bracket on the other end of the fixture. Operators bring rigid pipe down to the
threaded mounting hubs. Wiring is fed down through the rigid pipe to the junction box and tied in to the fixture’s lead wires,
completing the electrical connection. The adjustable L-shape mounting bracket provides support for the opposite end of the
fixture.
INSTALLATION PRECAUTIONS
Do not install fixture in any classified location where the marked operating temperature exceeds the ignition
temperature of the hazardous atmospheres.
Consult fixture nameplate for the suitability ambient temperature shown on the nameplate.
Refer to fixture nameplate for minimum supply wire temperature rating.
Verify that the supply voltage agrees with fixture rating as indicated on nameplate.
All local and national electrical/building codes must be followed when installing this lighting fixture. For
code interpretation, consult your local authority.
Product must be used only with glass tubes intact and all cap threads fully engaged. Do not use if glass tubes
are cracked or damaged.
