EPL-24-2L-LED-VISRED
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
4
INSTRUCTIONS FOR RELAMP
Caution:
Only use lamp size, type and/or wattage as shown on fixture nameplate.
1.
Disconnect power to the fixture prior to servicing.
FIGURE 1
2.
With a wrench, remove end-cap (lamp access cover) for the lamp you wish to replace.
Rotate counter-clockwise.
FIGURE 2
3.
Loosen the two lamp holder bracket screws holding the old lamp.
FIGURE 3
Twist and
remove the lamp holder bracket.
FIGURE 4
4.
Remove the old lamp and install the new lamp, seating lamp in opposite lamp holder.
FIGURE 5
5.
Replace lamp holder into position on the lamp. Twist slightly to place the lamp holder
bracket under screw heads and tighten the screws.
FIGURE 3
6.
Reattach end-cap. Rotate clockwise.
FIGURE 6
WARNING
4
To avoid risk of fire, explosion or electric shock, this product should be maintained by a qualified electrician only, in
accordance with all applicable codes and regulations.
4
To avoid electric shock: Be certain electrical power is OFF before and during maintenance.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
