P5
P6
Q2
Q1
GHIBLI 10:1 PNEUMATIC WASHING PUMP
Fig. 2P
Fig. 1Q
www.larius.com
14
REV.
02 - 06/2021 - Cod. 150186
•
Check the condition of every part of the motor.
•
For any replacement of the screws (
P5
) of the crosspiece
(
P6
), for their reassembly and correct adjustment see the
drawing below and the exploded view on page 16.
DISASSEMBLY OF THE
SUCTION VALVE
• Lift the pump from the fluid tank.
• Unscrew the suction valve.
• Remove the stop ball pin (
Q1
) and the ball (
Q2
). Check that
ball housing and ball are not ruined: then clean and/or replace
the parts.
• Insert again the ball and the stop ball pin. Adjust the ball
stroke according to the type of product being used. For thick
products, the maximum of the stroke (
place the stop ball pin
in connection with the upper holes of the suction valve
). For
very fluid products, the contrary.
Q
Close the compressed air supply to the pump
and release the residual pressure in the plant.
3,5 mm
