ML610Q304 Reference Board User’s Manual
FEBL610Q304RB-01
FEBL610Q304-01
7
2.4 When using sequential comparator ADC
Please connect to AIN0-AIN2 on the board to run the data through AD conversion.
If input from CN3 is not used, please input from the holes near CN3
Also, please add noise-reduction capacitor(s) C9-C11 as appropriate, if necessary.
See Figure 5 below as an example.
Figure 6, An example of ADC (sequential comparator) AIN0-AIN2 mounting
2.5 If LED does not emit
P20-P22 pins enable direct drive of LED. As LED(s) are connected to non-resitance chip(s) on this board,
SP7-SP9 should be removed if LED is not driven.
See Figure 6 below for rerence
.
Figure 7 SP7-SP9 Pads example
Top View
If no input from CN3,
please input directly
from these holes.
Put noise reduction
capacitors on these
holes.
Top View
Remove
