Appendix A: Command Reference
xPico® Wi-Fi® Embedded Device Server User Guide
92
configgroup Monitor Data
These settings pertain to
Monitor Data
in the device.
Data configured here will be accessible through the status of
Monitor
.
configitem Selector
value Name
Sets
Name
to enable the data selector.
Name
may contain up to 16 characters.
value Response
Sets
Response
instance to select the source of data. Response instance corresponds to Poll or Control
Message instance.
Blank the value for "<None>".
value Reference
Sets the
Reference
in dot number format.
Reference
selects the output of
Monitor Filter
. E.g. If data should select the second trunk of data created
by filter 1,
Reference
must be set to "1.2". A
Reference
of "0" indicates the raw response.
Dot number format could be "0" or two numbers separated by a dot (e.g. "1.2").
Reference
may contain up to 6 characters.
configgroup Tunnel Accept
Tunnel Accept Mode
controls how a tunnel behaves when a connection attempt originates from the
network.
configitem Mode
value
An Accept Tunnel can be started in a number of ways, according to its
Mode
:
Disabled:
never started.
Always:
always started.
Any Character:
started when any character is read on the Serial Line.
Start Character:
started when the Start Character is read on the Serial Line.
Modem Control Asserted:
started when the Modem Control pin is asserted on the Serial Line.
Mode
may be "Disable", "Always", "Any Character", "Start Character" or "Modem Control Asserted".
configitem Local Port
value
The
Local Port
value can be overridden. By default, it is 10001 for Tunnel 1, 10002 for Tunnel 2, and so
on.
Blank the display field to restore the default.
