5: Web and Command Line Interfaces
SLC™ 8000 Advanced Console Manager User Guide
63
The web page has the following components:
Tabs:
Groups of settings to configure.
Options:
Below each tab are options for specific types of settings.
Note:
Only those options for which the currently logged-in user has rights display.
Figure 5-2 Sample Dashboards
Dashboard
The appearance of the user interface dashboard will differ according to the type of NIC card
and bay modules installed in the back of the SLC 8000. See
Samples (Back Side) - Part Number SLC80482201S (on page 26), Figure 3-7
Port Connections (Back Side) (on page 40),
Sample Dashboards (on page 63)
-
The light green
LCD
button allows you to configure the front panel LCD.
-
The beige SD button allows you to configure the SD card, if a card is inserted. See
Chapter 8: USB/SD Card Port on page 146
-
The gray
U1
button allows you to configure the upper USB device (flash drive or modem)
plugged into the front panel USB connector. The gray
U2
button allows you to configure
the lower USB device plugged into the front panel USB connector. See
-
The brown
MD
button allows you to configure the internal modem, if an internal modem is
installed.
-
The blue
E1
and
E2
buttons display the
Network > Network Settings (1 of 2)
Ethernet port.
-
The
F1
and
F2
buttons display the
Network > Network Settings (1 of 2)
transceiver port.
-
The number buttons allow you to select a port and display its settings. Only ports to which
the currently logged-in user has rights are enabled.
Below the bar are options for use with the port buttons. Selecting a port and the
Configuration
Device Ports > Settings (1 of 2)
page. Selecting a
port and the
WebSSH
option displays the WebSSH window for the device port --if Web
SSH is enabled, and if SSH is enabled for the device port. Selecting the port and the
Connected Device
button allows access to supported devices such as remote power