Lantronix SISTP10 0-3-LRT Series, Install Manual, Page: 19 / 31

Lantronix SISTP10x0-3xx-LRT Install Guide
33733 Rev. G https://www.lantronix.com/ Page
19
of
31
Connecting to Power
After the Switch is mounted, connected, and grounded, use
t
he Terminal Block (Euro Block) to provide DC Power
Inputs P1 and P2.
Warning : Connect the wires to the terminal block before plugging power into the Switch product. Plug the
Terminal Block into the switch before powering on.
1. Insert the negative/positive DC wires into the
V-
and
V+
terminals, respectively.
2. To keep the DC wires from pulling loose, use a small flat-blade screwdriver to tighten the wire-clamp screws
on the front of the Terminal Block connector.
3. Plug the Power adapter plug into AC power at an appropriate AC outlet.
4. Check the SYS LED. If it is ON, the power connection is correct.
Adjusting Power Supply Output Voltage (+V ADJ)
+V ADJ
: access to small Phillips screw; turn clockwise to increase voltage. Adjustable, 48-55V.