Lantronix
SISTP10x0-3xx-LRT Install Guide
33733 Rev. G
Page
14
of
31
Install and Connect SFPs via Fiber Optic Cable
The Switch lets you install a Small Form-Factor Pluggable (SFP) device of your choice to make a fiber connection
via the 100/1000Base-X SFP Ports. See the Lantronix
for SFP models. See the related SFP manual for
safety precautions and warnings specific to your SFP model. The SFP ports should use UL Listed Optional
Transceiver products, Rated 3.3Vdc, Laser Class 1.
1.
Prepare a fiber optic cable with an appropriate connecter.
Warning
: The fiber optic port contains a Class 1
laser device. When the ports are disconnected, always cover them with the provided plug. Exposed fiber
optic ports may cause skin or eye damage.
2.
Remove a rubber plug from the Switch and position the SFP device at an SFP slot
with the label facing correctly.
3.
Carefully slide the SFP device into the slot, aligning it with the internal installation
guides. Ensure that the SFP device is firmly seated against the internal mating
connector.
4.
See the related SFP manual for operating information specific to your particular SFP
model.
5.
Connect the other end of the cable to the appropriate far end Ethernet port.
Note
: After the cable is properly connected at both ends, the Switch LED should be
for a description of LED operation.
See the related online
for operating information specific to your particular
SFP model.
Connect PoE+ Ports via TP Copper Cable
The Switch also provides 10/100/1000Base-T.
Supported cabling
: PoE per IEEE 802.3af PoE supports Cat 3 and Cat 5. PoE per IEEE
802.3at PoE+ supports Cat 5. See “
” on page
PoE/PoE+ information.
1. Prepare a twisted-pair copper cable.
2. Connect one end of the cable to the Switch.
3. Connect the other end of the cable to a PD, such as a VoIP phone.
Note
: After the cable is properly connected at both ends, the Switch
SYS
LED should be
on page