SDS2100 User Guide
3: Configuring the Unit
Modem Mode Command
Function
ATS0=n
Enables or disables connections from the network
going to the serial
port.
n=0 disables the ability to make a connection from the
network to the serial port.
n=1-9 enables the ability to make a connection from
the network
to the serial port.
n>1-9 is invalid.
ATEn
Enables or disables character echo and responses.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
ATVn
Enables 1-character response or full verbose.
n=0 enables 1-character response.
n=1 enables full verbose.
Note:
These AT commands are only recognized as single commands like
ATE0 or ATV1; compound commands such as ATE0V1 are not recognized
.
All other AT commands with Modem Mode set to full verbose acknowledge
with an OK, but no action is taken.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote Port
The remote TCP port number must be set for the unit to make outgoing connections.
This parameter defines the port number on the target host to which a connection is
attempted.
Note:
To connect an ASCII terminal to a host using the unit for login
purposes, use the remote port number 23 (Internet standard port number for
Telnet services).
DisConnMode
In DisConnMode (Disconnect Mode), DSR drop either drops the connection or is
ignored.
Note:
If you do not want to convert the binary numbers to hexadecimals
yourself, look up the values in
Table 6-4. Disconnect Mode Options
in the
Binary to Hexadecimal chapter.
37